Mini world game

The official game of Mini World has a gameplay that is quite similar to Minecraft, but the screen is updated to be brighter and more delicate. Players can enjoy the fun of adventure online with many friends, create freely, collect materials, and build almost any item!

Mini World official introduction

A highly free 3D sandbox game. There are no restrictions on levels and rules. There is no specific gameplay here, only the fun of destruction and creation. You can create a city, raise a group of small animals, and challenge the dark lord of the world. Volcanic floods can be created to change the world. Finally, you can share your world with other friends and have fun together.

Game features

--The single-player world is also very exciting, upload the archive for others to worship;

--No longer bound by time, place, or network;

--Survival mode is full of challenges, brothers face it together;

--Super cool panoramic 3D map, locate the direction of your home at any time;

--Infinite cubes, unlimited creativity, you can play whatever you want in creative mode.

Game guide

How to make a picture-destroying artifact in Mini World

--First of all, our sliding block device, put the marker (+) below, then add 3 wooden fences, then put the marker (-), put the sliding block and switch next to the marker (-), and then test it Whether it can operate normally;

--The "+" of the sliding block here should face the marker (-). Since the mini world currently cannot rotate props, you need to add an auxiliary block at the back first, and then place the sliding block and it will be ok~

--Then we add a conductive block on top of the minus block, so that our sliding block will malfunction after it is turned on, so that our first half is OK;

--Then we press the straight line and count 10 squares at the marker (+) position. At the 11th square position, prevent our launcher and auxiliary blocks (I placed a few blocks randomly, it does not have to be marked) (+)), then place our power generator and blue power wire as shown in the picture. This way we can see that our transmitter is powering up repeatedly.

--At this time, we can put a large number of rockets in the launcher. We can put as many rockets as powerful as we want. The launched rockets will be temporarily stored in the sliding square. If it is found that the rockets are not fired according to their position, Collect them and check to see if there are no empty 10-block distance~

--The rockets of the launching device are temporarily stored here. Now we only need to remove the switch, and all the rockets will be launched at the same time!

How to make mini world automatic door

--First use rocks to create a height of 4 blocks (the height depends on your own needs), then move the sliding block towards the direction where the door will be placed later (that is, the + sign faces the marker), make two auxiliary blocks at the back, and then Put the sliding block on the auxiliary block and you will be successful.

--Then knock off the excess auxiliary blocks at the back, place a marker (-) on the front of the sliding block (+ side), place a marker (+) on the bottom layer, and fill the middle with a transparent glass piece .

--The next step is to lay the circuit. First, dig a "U"-shaped pit two grids deep around us;

--Add a rock on the opposite side of the sliding block from the marker, and then connect the power line down.

--The U-shaped pit is covered with power lines, cover the power lines with soil blocks, and place touch-sensitive pressure plates on the ground when entering and exiting to ensure that they can be stepped on when entering and exiting;

--At this time, the basic internal structure of the automatic door is ready. When you step on the pressure-sensitive plate, the door will rise, and when you leave the door, it will fall. The next step is packaging.