pac194x

Rust pac194x Power Monitor Driver

A platform-agnostic driver crate for the Microchip pac194x single/multi channel power monitor using the embedded-hal traits.

This driver allows you to:

• Read/Write every available register as a Rust data structure, allowing you to configure alerts, averaging, etc.
• Read the bus and sense voltages directly as f32s

Usage

To use this driver, import this crate and an embedded_hal implementation, then instantiate the appropriate device.

use linux_embedded_hal::I2cdev;
use pac194x::{pac194x, AddrSelect};

const SENSE_RESISTOR: f32 = 0.5;

fn main() {
    let i2c = I2cdev::new("/dev/i2c-1").unwrap();
    let mut sensor = pac194x::new(i2c, AddrSelect::GND).unwrap();
    loop {
        let bus_voltage_1 = sensor.read_bus_voltage_n(1).unwrap();
        let sense_voltage_1 = sensor.read_sense_voltage_n(1).unwrap();
        println!("Channel 1 has a bus voltage of: {:.2} V", bus_voltage_1);
        println!("Channel 1 is pulling a current of: {:.2} A", sense_voltage_1 / SENSE_RESISTOR);
    }
}

Discussion

I wrote a blog post about the development of this crate here

License

Licensed under either of

• Apache License, Version 2.0 (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)
• MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT)

at your option.

Contributing

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.