The Minecraft game has been very popular recently. How to make a Minecraft Diamond Detector is also a question that everyone is paying close attention to. Many friends don’t know exactly how to do it. In fact, it doesn’t matter if you don’t know how to do it. Now the editor of this website I will share with you how to make a diamond detector in Minecraft, don’t miss it.
1. In Minecraft, players can get command blocks by typing /give @s command_block. This time, a total of 4 command blocks and 1 lever are needed. Place the command blocks as shown in the picture.
2. Then the player enters clear @p compass 0 0 in command block 1. The block type is set to loop, the condition is unconditional, and the red stone is set to red stone control.
3. Then enter execute @p ~~~ fill ~~~ ~ 1 ~ diamond_block 0 replace diamond_ore in command block No. 2. Set the block type to chain, the condition to conditional, and the redstone to remain open.
4. Enter execute @p ~~~ playsound note.banjo in command block No. 3. Set the block type to chain, the condition to conditional, and the redstone to remain open.
5. Enter execute @p ~~~ fill ~~~ ~ 1 ~ diamond_ore 0 replace diamond_block in command block No. 4. Set the block type to chain, the condition to conditional, and redstone to remain open.
6. After all instructions are input, pull down the lever. Adventurers only need to hold the compass and walk on the road. When they reach directly above the diamond ore, the compass will make a beep sound.
