Oil well development module construction: the first step is to build the frame, the module size is 9X7, the second step is to pour oil and vacuum, pay attention to pouring crude oil, the third step is to build the building, choose at least gold amalgam as the material, if there is steel, you can choose steel, the fourth step When building a background building, wires can be connected casually, thick or thin wires will do. You can use lead. Water pipes can also be connected casually. Oil wells can only be connected to clean water, not miscellaneous liquids. Be sure to note that for automation, you can use lead. Select natural gas as the gas pipeline element sensor, and connect a NOT gate (the NOT gates should not be connected at the beginning and end). The upper hydraulic sensor setting is less than 500Kg, and the lower setting is greater than 50Kg.
Details of the construction method of the oil well development module of "Hypoxia"
Personally, I do not recommend using high-pressure liquid reservoirs to develop oil reserves, because it is useless if there is too much crude oil. It is nothing more than a waste of water and manpower. It also increases the risk of high-pressure liquid reservoirs out of thin air. You only need to store a sufficient amount of crude oil.
The first step is to build the framework. Module size 9X7
The second step is to pour oil and vacuum. Note that crude oil must be poured.
The third step is to build a building. The material should be at least gold amalgam. If there is steel, you can choose steel.
Since it is inconvenient to build inside, you can temporarily remove the middle brick and replace it with a ladder. The upper right corner is the gas pipeline element sensor (select natural gas), and the one in the middle is the clone motion sensor. Remember to put 4 granite temperature-changing plates behind the oil well.
The fourth step is to build the background building
Wires can be connected at will, thick or thin wires will do, you can use lead
Water pipes can be connected casually. Oil wells can only be connected to clean water, not miscellaneous liquids, so be careful.
For automation, lead can be used. For the gas pipeline element sensor, choose natural gas. Connect a NOT gate (the NOT gates should not be connected from end to end). The upper hydraulic sensor setting is less than 500Kg, and the lower setting is greater than 50Kg.
For ventilation ducts, pay attention to the fact that the duct bridge must not be connected incorrectly.
Finally, just change the previous ladder back to insulating bricks, and then connect the oil well to water and start working. It is best to set the priority of the oil well to 9, because the oil well requires villains to come and operate it from time to time.