Teach you how to simply change the color atmosphere of your photo environment

Material picture

renderings
The beautified renderings

The light source when I was shooting this picture was quite complex. The one near the window was normal natural light. Since the contrast between indoor and outdoor light was very strong, I didn’t bring a U2 light at the time, so I had no choice but to turn on the desk lamp to fill in the light. Mixed light sources with two low color temperatures require special attention when processing post-processing.
The processing of this painting is not very big. It is just a matter of choosing the right color tone. When I was processing it, I considered that girls would not like the too strong color, so I lightened it a lot, but I also wanted to maintain the reflection effect of the environment as much as possible. , especially to maintain and create the romantic and warm atmosphere of the coffee shop as much as possible.
The above picture of a teacher from the “urban poor” is quoted with relevant text.

1. Open the material picture, switch to Lab mode, create a curve adjustment layer, and adjust the brightness, A, and B channels.

-
After this step of processing, the environmental color of the photo has been improved to a certain extent.

Stamp the image (ctrl+shift+alt+e) to get layer 1.

3. Close layer 1, select the Curves adjustment layer, and change the layer blending mode to "Screen".

4. Select layer 1, create a layer mask, set the foreground color to: 535353, and use a brush to paint on the characters.

5. Stamp the layer, enter the channel panel, and sharpen the brightness channel. Select Filter-Sharpen-USM Sharpen. Set the parameters as shown below. At this point in the process, the environmental color of the photo has been greatly improved. Operation Finish.

Completed renderings.