Many players have encountered such a problem in Outpost Reloaded. This problem is the guide to scanning the entire image of Outpost Reloaded. Only by solving this problem can players play more happily in the game, so the editor of Source Code Network went through the information and mechanisms of this game, and finally found a solution for everyone. Let’s take a look at the editor of Source Code Network Let’s compile a guide for everyone.
After entering the game normally, you will use the z key to scan the entire image, but the step is more cumbersome. You need to click m and then select the central control tower. There are two ways to do this step. One is to select it through the shortcut bar (as shown in Figure 1), and the other is to Directly click on the central control tower, but both of these methods are more troublesome in later scanning.
At this time we can use the formation function of the base as follows.
First, return to the base and click m to enter this interface.
Then click on the construction outpost above, click on edit design, and then click on this icon.
After entering debugging mode, select the base (central control tower).
Then press ctrl plus the number keys to create a formation.
You can use ctrl+1 directly here.
After the operation is completed, exit and save, and then in the game we can quickly complete the scan through the following steps.
Press m first, then 1, then z.
If you get what you need through this guide on full-image scanning techniques for "Outpost Reloaded", then remember to share this guide with other players, so that other players don't have to worry about this problem and can enjoy the game wholeheartedly. , experience the joy brought by the game.