It seems like I haven’t made a machine for a long time~ Do you miss the days when you were dominated by red stones? It’s been a while since I made a machine! Let's start with something simple. Let’s take a look at this 3x3 piston door!
First dig a 7×7×3 pit
Place a row of quartz blocks in the middle
Quartz blocks are used to
It is convenient for everyone to see the structure of the machine
You can replace it with any solid block
Then place five parts of redstone powder on the quartz block
Then place two quartz blocks at both ends
Then on both sides of the three quartz blocks in the middle
Place a total of six redstone torches
on redstone torch
Place six sticky pistons
Then on the quartz blocks at both ends
Place a redstone torch on each
Then place the quartz block on the redstone torch
On the basis of just now
Place two redstone torches
Behind the quartz block just now
Then place the quartz block on the redstone torch
Then on the quartz blocks at both ends
Place a redstone torch on each
Place a quartz block on the redstone torch
Then as shown in the figure
Place four sticky pistons on one side
Place a total of eight
Eyes move to the right of the structure
Place five quartz blocks as shown in the picture
Place five parts of redstone dust on top of them
Then at the red dot in the picture
Place two sticky pistons pointing downwards
Then at the red dot in the picture
Place two sticky pistons pointing downwards
Next is a very important structure
For everyone to see clearly
Show it to everyone with gold nuggets
While everyone is doing it
It can still be replaced with other solid blocks
Place the five gold nuggets as shown in the picture
place a detector
Let the direction of the redstone signal be upward
Then put three parts of redstone powder in the position shown in the picture
Place two redstone repeaters as shown in the picture
and mark the redstone repeater with the red dot
Adjust to second gear
All that's left is the trigger.
Place a redstone repeater as shown in the picture
three quartz blocks
and five parts redstone powder
Then use three quartz blocks and place them on top of the redstone powder
Place three more pressure plates on top
Then place the redstone repeater at the red dot
Adjust to second gear
Follow the same pattern again
Mirrored on the other side of the door
Make the same trigger device
Finally, fill the floor and walls with bricks
Then use stone bricks to place where each sticky piston protrudes.
This 3×3 piston door is completed
when you walk over
The 3×3 piston door will open
Such automatic piston door
You can move it to
The entrance to any cave
Startup speed is quite fast
If you want to see some other devices,
You can comment below~
Click to see it! Share your world!