Adjust the color of the photo into a pure color

-
Original picture

final renderings

Let me briefly talk about my ideas in color adjustment: If you want to adjust the color the same as others, you must first compare other people's materials and results, find out the differences, and then make corresponding adjustments.
After comparing the original image and the result, I think we should make a fuss about the comparison of the image first. The contrast of the result image is stronger than the contrast of the material image. Then we can use the "Level" or "Curve" command here to enhance the contrast of the image. contrast.

1. To enhance the contrast of the image, it means that the bright ones are brighter and the dark ones are darker. After executing the "Levels" or "Curves" command, in the pop-up dialog box, use the three buttons below the small eyedropper tool area. click the "OK" button to complete the adjustment to enhance the contrast.

2. Compare the original image and the resulting image again. You will find that although the contrast in brightness seems to be enhanced, the saturation has been reduced a lot, so we execute the "Hue/Saturation" command to reduce the saturation of the image.

3. Comparing the desaturated image with the result image, I found that there was still a difference. It was obvious that such an effect must be coupled with a color mask, so I immediately thought of the "Photo Filter" command. After using it, the effect did not achieve the expected effect, so I was very disappointed. However, I am a lazy person and I will not think about problems that I can't think of, so I fell asleep on the bed, feeling dazed. After getting up half asleep, I casually added a new layer to the picture and painted it green.

5. Change the blending mode of the layer to "Color", compare it with the rendering again, and find that the color of the lower half is OK, but the difference is the upper half, so the light flashes and double-clicks on the thumbnail of the layer. . In the pop-up layer style dialog box, set the "Mixed Color Band" as shown in the figure below (the small triangle needs to be separated by holding down the Alt key)

5. Click the "OK" button to complete the color adjustment.