This tutorial introduces how to use Photoshop to create a warm and cold picture effect. It mainly uses Photoshop’s basic color grading tools to create a unique effect of “warm and cold celestials”. It is very helpful for beginners to become proficient in Photoshop’s color grading tools. Hope it helps! For more tutorials, please view the special Photoshop color correction tutorial on this site.
This article was translated and compiled by Derek-Yu from China Tutorial Network. Please keep this information when reprinting!
This tutorial refers to foreign website tutorials. The copyright of the pictures and tutorials belongs to the original website and is for learning and exchange only.
Original picture:
renderings
material:
Here are the steps:
Step 1: Open the original image in photoshop and press the shortcut key Ctrl+M to slightly brighten the original image, as shown below:
Figure 1
Step 2: Use the rectangular marquee tool to pull out the selection as shown below. Note that the right border of the selection should be placed in the middle of the tree trunk, so that the effect is better.
Figure 2
Press the shortcut key Ctrl+J to copy a layer of "Layer 1", hold down the Ctrl key and click "Layer 1" in the layer panel to load the selection, return to the background layer, and press the shortcut key Ctrl+J again to copy a layer of "Layer 1". Layer 2", thus simply dividing the original image into two parts, as shown below:
Figure 3
Step 3: Click on layer 1 in the middle of the layer panel to put it in editing mode. Press Ctrl+B to adjust the color balance of layer 1. The parameters are as follows:
Figure 4
Step 4: Press the shortcut key Ctrl+U to adjust the hue and saturation of layer 1. The parameters are as follows:
Figure 5
At this point, the adjustment of the left half is completed, and the effect is as follows:
Figure 6
Step 5: Click layer 2 in the middle of the layer panel to put it in editing mode, press Ctrl+B to adjust the color balance of layer 2. The parameters are as follows:
Figure 7
Step 6: Execute the menu command: Image》Adjustment》Photo Filter, and heat layer 2. The parameters are as follows:
Figure 8
At this point, the adjustment of the left and right sides is completed, and the effect is as follows:
Figure 9
Step 7: Sharpen, click layer 1 in the middle of the layer panel to put it in editing state, press the shortcut key Ctrl+Alt+Shift+E to stamp the layer to get "Layer 3", and execute the menu on layer 3 Command: Filter > Sharpen > Sharpen, the effect is as follows:
Figure 10
Step 8: Open the texture material, use the move tool to drag the texture into the file you just edited to get "Layer 4", align it, and change the blending of Layer 4. The effect when the mode is "Overlay" is as follows:
Figure 11
Step 9: Finally, add simple text modifications, complete, and save. The final effect is as follows:
Figure 12
